Bought a new HP ENVY 5010 printer - arrived today......plugged it in but all I get on printer screen is 'A paper tray is open. Close the tray to continue.' Showed up as soon as I turned it on after a few seconds of warming up - haven't even opened the tray yet....checked it opened it afterwards, closed it (made that click) but no matter what the message persists and I can't get any further with setting up......haven't found anything useful online so far to help the issue. Anyone had the same problem? Any suggestions? If it's no easy fix I'll just send it back.
Check for obstructions that prevent the input tray from closing
Press the Power button to turn off the printer.
Grasp the handle on the input tray, and then pull the tray toward you to open it.
Figure : Pull to open the paper tray
Remove any loose sheets of paper from the input tray or any paper that blocks the photo tray.
Remove the output tray, and then set it aside.
Figure : Remove the output tray
Turn the printer onto its right side so you can access its underside.
Check the gap where the input tray was. Remove any loose paper or other obstructions in the gap. If any paper is jammed inside the gap, grasp the paper with both hands, and then pull the paper slowly but firmly toward you to remove it. Gently remove any jammed paper and bits of torn paper.
Figure : Turn the printer onto its right side, and then remove any obstructions
Remove paper from the gap as carefully as possible. If any torn pieces of paper remain inside the printer, a paper jam is likely to occur, which could damage the print mechanism.
Turn the printer back over to its normal position, and then reinsert the input tray, pushing it into the printer until it locks into place.
Figure : Push in the paper tray
The tray clicks into place when it is completely closed, and the printer makes noise.
Grasp the output tray by the sides, and then replace the output tray onto the input tray.
Press the Power button to turn on the printer.
Wait until the printer finishes warming up, and then check the control panel to see if the error message has cleared.
Refer this HP document for more assistance:- Click here
(Note:- Though this printer model is not mentioned in this document, still, these steps should fix)
I hope that helps.
To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.
Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".