wireless radio on deskjet 2622 turned off

[dfurness]

I set up the printer yesterday, and all was working.  Now, the blue light keeps blinking.  The wireless network test results says the wireless radio on your HP printer is turned off.  Please tell me how to turn it on my deskjet 2600 all in one printer.  Thank you

[TEJ1602]

@dfurness, Welcome to HP Support Community!

Connect the printer with WPS

Use WPS to connect the printer to your wireless network.

1. Locate the WPS button on your router, but do not press it yet.

   If your router does not support WPS, skip to the next step to connect the printer with the HP Smart app.

2. Turn on the printer. If the printer is in sleep mode, press the Cancel button on the control panel.

3. On the printer control panel, press and hold the Wireless button  for at least 3 seconds or until the wireless light starts to flash.

4. On the router, press and hold the WPS button for 3 to 5 seconds or until it shows that the WPS connection process has started.

   NOTE: 

   The printer stops searching for a WPS connection two minutes after the wireless button is pressed. If you were unable to press the WPS button within that timeframe, attempt these steps again.

   Once the printer connects to the wireless network, the blue Wireless light on the control panel turns on solid.

If the printer fails to connect to your wireless network, continue to the next step.

Connect the printer with the HP Smart app

Use the HP Smart app to connect the printer to your wireless network.

1. Make sure your computer is connected to your wireless network.

2. On your computer, download and install the HP Smart app from the Microsoft store.

3. Turn on the printer. If the printer is in sleep mode, press the Cancel button on the control panel.

4. Press and hold the Wireless and Cancel buttons until the Wireless light and Power light starts to flash. You must complete the network setup within 2 hours.

5. On your computer, open HP Smart, and then click the Printer icon 

6. Click Set Up a New Printer, and then click Continue.

   HP Smart searches for printers on your wireless network.

7. Select your printer, and then click Continue.

8. When prompted, type the WEP or WPA key (network password).

   If you do not know your network password, go to Find Your Wireless WEP, WPA, WPA2 Password.

9. After the printer connects to your wireless network, click Continue, and then click Exit Setup.

   Once the printer connects to the wireless network, the blue Wireless light on the control panel turns on solid.

Hope this helps!

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!