Error message "Could not complete scan".

[ve3coo]

When message said couldn't communicate with printer I use Scan Doctor which istalled new software.  Still had same problem.  Restarted both computer and printer to see if new software had to be recognized, but not message says "Could not complete scan".

Been through Scan Doctor several times, Tried HP's Virtual Assistant without success.

Lost!

**bleep**

[Roopa-S]

@ve3coo

Welcome to HP Forums, 
This is a great place to get support, find answers and tips. Thank you for posting your query. I'll be more than glad to help you out 🙂 

To diagnose this issue, try to copy a document from the scanner glass.

If copy works fine, reinstall the printer driver. Use the method below to remove all existing print drivers installed on your PC:
1.) In Windows, search for and open Programs and features
2.) Select your HP Printer
3.) Select Uninstall
4.) In Windows, search for and open Devices and printers
5.) In the Devices and Printers windows look for your HP printer. If you see it listed right-click on it and choose 'Delete' or 'Remove Device'
6.) Open up the run command with the "Windows key + R" key combo.
7.) Type printui.exe /s and click Ok. (Note: there is a space in between “printui.exe” and “/s”)
8.) Click on the "Drivers" tab
9.) Look for HP Printer driver. If you see it Click on it and click Remove at the bottom
10.) Select Ok
11.) Select Apply and Ok on the Print Server Properties windows
12.) Close Devices and Printers
Once the drivers are removed, to download and install the software and driver: Click here

If copy does not work, try printer reset:
Turn on the printer.
Wait until the printer is idle and silent before you continue.
Disconnect the USB cable from the rear of the printer. If your printer has a network or wireless connection, leave it connected.
Remove the ink cartridges from the printer.
With the printer turned on, disconnect the power cord from the rear of the printer and from the wall outlet or power strip.
Wait at least 60 seconds.
Plug the power cord back into the wall outlet.
   NOTE: HP recommends connecting the printer power cord directly to a wall outlet.
 Reconnect the power cord to the rear of the printer.
Turn on the printer, if it does not automatically turn on.
The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.
Wait until the warm-up period finishes and your printer is idle and silent before you proceed.
Reinsert the ink cartridges, and then close the ink cartridge access door.
If you receive a prompt to print a calibration page, do so.
If you disconnected the USB cable, reconnect it to the rear of the printer.
Try to copy and print.

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping!