Scanner Errot Code 0X02A6C2ED SM-MODULE C

[HeHa1]

Scanner is not working; I get the message: switch printer off; when doing so the screen on the printer says: E

ERROR CODE: 0X02A6C2ED

SM-MODULE C

[Jay_G24]

 Hi @HeHa1,

I'd like to help!

Try the below suggestions -

Reset the product

With the printer turned on, disconnect the power cord from the rear of the printer.

Unplug the power cord from the wall outlet.

Wait at least 60 seconds.

Plug the power cord back into the wall outlet.

Reconnect the power cord to the printer.

Turn the printer on. HP recommends plugging the printer directly into a wall outlet.

Remove the ink cartridges and reset the printer.

1. Remove the ink cartridges from the printer.

2. With the printer turned on, disconnect the power cord from the printer.

3. Unplug the power cord from the power source.

4. Wait at least 60 seconds.

5. Reconnect the power cord to a wall outlet and to the printer.

   NOTE: 

   HP recommends plugging the printer directly into a wall outlet.

6. Turn the printer on.

7. Reinsert the ink cartridges, and then close the ink cartridge access door.

8. If you receive a prompt to print a calibration or alignment page, do so.

If the error message persists, continue to the next step.

 Also, try updating the printer's firmware -HP Printers - Updating or Upgrading Printer Firmware  

If the issue persists, I'd suggest you Contact HP in your region regarding the service options for your printer

Hope this helps! Keep me posted. 

And, Welcome to the HP Support Community. 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping