cancel
Showing results for 
Search instead for 
Did you mean: 
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
Ovi11
New member
1 0 0 0
Message 1 of 3
327
Flag Post

HP z9 plotter will freeze on the HP logo after a while

HP Recommended
HP z9

I have a HP z9 plotter with the latest firmware. After a while in standby the plotter will only show the HP logo and I need to unplug the power for the plotter to work again

Tags (1)
2 REPLIES 2
Semaphore
Level 3
33 33 3 9
Message 2 of 3
Flag Post
HP Recommended

Try running an EEROM reset, followed by a JDI reset, then restore all factory settings.

Was this reply helpful? Yes No
Ouccema
Level 4
Level 4
116 116 9 15
Message 3 of 3
Flag Post
HP Recommended

Hello,

 

To avoid any network miscellaneous, can you check if we get the same issue when keeping the plotter without the network cable?

I am an HP Employee.
Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation