08-23-2019 11:50 AM
Hi,
I've tested with:
VVX311/VVX411/VVX250
Tested with firmwares: 5.8.3.2414 / 5.9.2.3446 / 5.9.3.2857 / 6.1.0.6189
Attached is a quick picture of a sample packet capture
Only when using opus codec, not when using any other codec, when I place a call on hold, then resume the call, there is one way audio. It appears that the polycom phone is picking up a different RTP version payload type when the call is taken off hold. We can also replicate this issue when pressing the conference button (technically it places the caller on hold) and then cancelling the conference.
This only happens on incoming calls to the polycom phones, and I am unable to replicate this with any other vendor phone, even using the same IP PBX (asterisk 13 pjsip). When we place outbound calls, this issue does not exist.
Aby suggestion on where to go from here?
Not using SRTP (I saw a related post about SRTP issues). Don't know what else to try at this point. I've hit a wall.
Thanks in advance
08-23-2019 01:16 PM
Hello @ja1331 ,
Welcome back to the Poly Community.
The next step would be a support ticket.
In order to raise a support ticket, you need to work with your Poly reseller as they may need to do this for you.
End Customers are usually unable to open a ticket directly with Poly support.
If this is some sort of an Internet discounter providing your MAC address or your Poly devices serial will enable us to look up who would be able to support you. This may not be who you purchased the Poly device from.
If the unit is no longer within the warranty please be prepared to Pay Per Incident / PPI. This is all outlined in detail here
Please ensure to provide some feedback if this reply has helped you so other users can profit from your experience.
Best Regards
Steffen Baier
08-24-2019 04:55 AM
Hello @ja1331
SCANSOURCE INC sold this VVX250 back in 28/02/2019. This means it is still in warranty and they can open a Ticket with Poly support for you.
Best Regards
Steffen Baier