Printhead error, won't print any reports

[justsmile986]

Hello, my HP Officejet Pro 6830 won't print anything. I keep getting a printhead error, but when I try to clean nothing happens. It stays on the same screen like I didn't click anything. I was getting the error before so I did a little research, installed new ink today, I've tried unplugging multiple times in multiple ways, I made sure the latest software is downloaded, and it won't even let me print any report page. Please help, I just bought this from someone. Thanks! 

[Jay_G24]

Hi @justsmile986,

I'd like to help!

Try the below suggestions-

Reset the product

• With the printer turned on, disconnect the power cord from the rear of the printer.
• Unplug the power cord from the wall outlet.
• Wait at least 60 seconds.
• Plug the power cord back into the wall outlet.
• Reconnect the power cord to the printer.
• Turn the printer on. HP recommends plugging the printer directly into a wall outlet.

Update the printer firmware

Updating the printer firmware might resolve printhead problems. Go to Updating or Upgrading Printer Firmware for more information.

Check the carriage for a printhead latch

Look at the carriage to see if it has a latch. The carriage is the part inside the printer that holds the printhead and cartridges. If the carriage does not have a latch (fixed printhead), then the only option is to service the printer.

1. Open the door to access the cartridges.

2. Wait until the carriage stops moving before you continue.

3. Look at the right side of the carriage to see if the carriage has a printhead latch (a handle that can be raised, which allows the printhead to be removed).

   • If your carriage has a printhead latch, continue to the next step.

   • If your carriage does not have a printhead latch (fixed printhead), skip to Service the printer. If the printhead is fixed, then there are no additional troubleshooting steps available.

Example of a carriage with a printhead latch

Example of a carriage without a printhead latch

Hope this helps! Keep me posted. 

And, Welcome to the HP Support Community. 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping