Cartridge Failure

[Katiejparrish]

I just got a new cartridge and printed a few photos. I turned off the printer and when I turned it back on it says "Cartridge failed. Please replace cartridge." I have taken the cartridge out and clean both it and the inside of the port but continue to get the same message. What do I need to do to fix it?

[Riddle_Decipher]

@Katiejparrish We got you covered, here's a list of steps that should help resolve the issue, let's get started:

Step 1: Reset the printer to recover from printer failures.

1. With the printer turned on, disconnect the power cord from the printer.

2. Unplug the power cord from the power source.

3. Wait 60 seconds.

4. Reconnect the power cord to a wall outlet and to the printer.

   NOTE: 

   HP recommends plugging the printer directly into a wall outlet.

If the error message persists, continue to the next step.

Step 2: Remove the ink cartridges, and reset the printer

Remove the ink cartridges and reset the printer.

1. Remove the ink cartridges from the printer.

2. With the printer turned on, disconnect the power cord from the printer.

3. Unplug the power cord from the power source.

4. Wait at least 60 seconds.

5. Reconnect the power cord to a wall outlet and to the printer.

   NOTE: 

   HP recommends plugging the printer directly into a wall outlet.

6. Turn the printer on.

7. Reinsert the ink cartridges, and then close the ink cartridge access door.

8. If you receive a prompt to print a calibration or alignment page, do so.

P.S: Welcome to HP Community 😉

Keep us posted,

If you would like to thank us for our efforts to help you, 

Give us a virtual high-five by clicking the 'Thumbs Up' icon below, followed by clicking on the "Accept as solution" on this post, 

Have a great day!