Error Code flashing

[TashaB]

I have just installed my printer and tried to print my first test page but the printer is now flasing the following error code 0XB8D082FE and even if I switch the printer on and off it keeps coming back. 

[sandytechy20]

@TashaB

Welcome to HP forums, I see that you are getting 0XB8D082FE error code.

Reset the printer

1. Turn on the printer.

2. Wait until the printer is idle and silent before you continue.

3. Disconnect the USB cable from the rear of the printer. If your printer has a network or wireless connection, leave it connected.

4. Remove the ink cartridges from the printer.

5. With the printer turned on, disconnect the power cord from the rear of the printer and from the wall outlet or power strip.

6. Wait at least 60 seconds.

7. Plug the power cord back into the wall outlet.

   NOTE: 

   HP recommends connecting the printer power cord directly to a wall outlet.

8. Reconnect the power cord to the rear of the printer.

9. Turn on the printer, if it does not automatically turn on.

   The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.

10. Wait until the warm-up period finishes and your printer is idle and silent before you proceed.

11. Reinsert the ink cartridges, and then close the ink cartridge access door.

12. If you receive a prompt to print a calibration page, do so.

13. If you disconnected the USB cable, reconnect it to the rear of the printer.

14. Try to print.

Update the printer firmware

Refer this HP document for the steps to update the printer firmware:-  Click here

If the issue persists, I am sending you a private message. Please check the mailbox icon at the top-right corner of this screen.

I hope this helps resolve this issue completely.

Let me know how it goes.

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

Cheers.