HP Envy 5530 - replacement error cartridge... How to bypass when cartridge has ink?

[AdamFTL]

I am getting a "the following ink cartridge must be replaced" The ink cartridge is new and how can i bypass this so i don't have to go and return.  I know they work because it printed from Alexa one complete sheet.  Can you please send me the steps to bypass?

Thanks, 
Adam

[Jay_G24]

Hi @AdamFTL

Welcome to the HP Support Community. 

Try the steps below -

Reset the product

• With the printer turned on, disconnect the power cord from the rear of the printer.
• Unplug the power cord from the wall outlet.
• Wait at least 60 seconds.
• Plug the power cord back into the wall outlet.
• Reconnect the power cord to the printer.
• Turn the printer on. HP recommends plugging the printer directly into a wall outlet.

The following steps apply to all printers with only two cartridge slots (black and tri-color).

NOTE: 

If you do not have a replacement cartridge readily available and need to print, remove the cartridge indicated in the error message to initiate single-cartridge mode. Acknowledge any prompts on the computer or printer, and then submit the print job. Be sure to complete the steps in this section before you install any new cartridges.

Step 1: Clean the electrical contacts

Remove the cartridge indicated by the error message, clean the electrical contacts, and then reinsert the cartridge in its color-coded slot.

1. Turn the printer on.

2. Open the door to access the cartridges.

3. Wait until the carriage stops moving before you continue.

4. Remove the cartridge indicated in the error message from its slot, holding it by its side.

      CAUTION: 

   Do not touch the copper-colored contacts or the ink nozzles. Touching these parts can result in clogs, ink failure, and bad electrical connections.

5. Remove any protective tape that still might be on the contacts.

      CAUTION: 

   Do not touch or try to remove the copper electrical strip.

   

6. Lightly dampen a lint-free cloth with distilled water, and then clean only the copper-colored contacts on the cartridge.

   

7. Lightly dampen a lint-free cloth with distilled water, and then clean the electrical contacts in the carriage, located inside the printer.

   

8. Wait 10 minutes for the contacts to dry.

9. Reinsert the cartridge.

   • Insert the black cartridge into the right slot.

   • Insert the tri-color cartridge into the left slot.

10. Repeat these steps for the other cartridge, if necessary.

11. Close the cartridge access door.

12. If the error persists, repeat the previous steps to clean the cartridge and carriage contacts a second time.

13. Check for the error message.

single cartridge mode 

The printer you own can work in single-cartridge mode, wherein the printer will be able to print with one cartridge in the printer.which will help us identify if its a cartridge issue or a printhead issue.

To try single-cartridge mode follow the below steps:

remove the black ink from the printer, leave the color in and try printing 
then remove the color ink and, insert the black  in and try printing 

Hope this helps! Keep me posted. 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping