HP OfficeJet 8610 - New - Cartridge or Printhead Problem, error message states Printhead Damaged

[tRISH60]

I need to know can this be fixed or do I need to get another printer.

ERROR: Printhead damaged or missing

Model: HP Officejet Pro 8610

Model # A7F64A

Serial Number : edited*

Service ID: 25195

Patricia Murray

edited **

[Raj1788]

@tRISH60

Thank you for joining the HP Community

Reseat the printhead

Follow these steps to reseat the printhead.

NOTE: 

You do not need to remove the printhead from the carriage.

Step 1: Unseat the printhead

1. Slip your fingers into the slot on the left side of the printer, and then pull forward to open the cartridge access door. The carriage moves to the left side of the printer. Wait until the carriage is idle and silent before proceeding.

   Figure : Open the cartridge access door
   

   1. Slot on the left side of the printer

2. Unplug the power cord from the rear of the printer. Unplugging the printer prevents the carriage from moving.

      WARNING: 

   You must disconnect the power cord before reaching inside the printer to avoid risk of injuries or electric shock.

3. Lift the carriage latch.

   Figure : Lift the carriage latch

   

4. Grasp the sides of the printhead, and then slightly lift the printhead without fully removing it from the carriage.

   Figure : Slightly lift the printhead

   

Step 2: Reseat the printhead, and then lower the carriage latch

1. Reinsert the printhead into the carriage to reseat it. As you guide the printhead into the carriage, it settles into the carriage as it seats.

   Figure : Reseat the printhead

   

2. Gently rock the printhead to the left and right to make sure that the printhead fully seats in the carriage.

3. Lower the carriage latch.

   Figure : Lower the carriage latch

   

4. Make sure that the carriage latch is down.

   Figure : Carriage latch positions
   

   1. Carriage latch is up

   2. Carriage latch is down

5. Close the ink cartridge access door.

6. Reconnect the power cord to the rear of the printer.

7. If the printer does not turn on by itself, press the Power button to turn it on.

8. Wait until the warm-up period finishes and your printer is idle and silent before you proceed.

If the issue persists, refer to this document: https://support.hp.com/us-en/product/hp-officejet-pro-8610-e-all-in-one-printer-series/5367603/docum... for Resolving Printhead Problems and Ink System Failure.

Keep me posted, how it goes!

If the information I've provided was helpful, give us some reinforcement by clicking the Accepted Solution and Kudos buttons, that'll help us and others see that we've got the answers!

Have a great day!

Cheers:)