Hp 6869 will not print at all.

[Geary3]

 HP printer 68-69 will not print at all replaced all inks with brand new HP ink and printer will still not print only a blank page comes out

[Mans]

@Geary3 

Hello,

Do you use genuine HP cartridges?
Are you registered for HP Instant Ink?

Please update the printer firmware with the HP link below.
https://ftp.hp.com/pub/softlib/software13/printers/ojp6960/1910a/OJP6960_1910A.exe

Refer to this document for the steps to update the printer firmware.

In some cases, remove the ink cartridges and reset the printer can solve the error.

1. Turn on the printer.
2. Before continuing, wait until the printer is idle and silent.
3. Disconnect the USB cable from the back of the printer. If your printer has a network or wireless connection, leave it connected.
4. Remove the ink cartridges of the printer.
5. With the printer turned on, unplug the power cord from the back of the printer and from the wall outlet.
6. Wait at least 60 seconds.
7. Plug the power cord into the outlet.

   NOTE:  HP then recommends reconnecting the printer's power cord directly into a wall outlet.

8. Reconnect the power cord to the back of the printer.
9. Turn on the printer, if it does not automatically make it.
   It is possible that the printer goes through a warm-up cycle. It is also possible that the printer lights blink and the carriage moves.
10. Wait until the preheat cycle and until the printer is idle and silent before continuing.
11. Reinsert the ink cartridge, and then close the access door to the cartridges.
12. Print a calibration page, if prompted.
13. If you disconnected the USB cable, reconnect it to the back of the product.
14. Try to print.

In case of need, please do not hesitate to solicit us.

Best regards,