New cartridge and the message it must be replaced

[mlang]

I have an HP Envy 5535.  Yesterday I replaced the black print cartridge after being prompted.  I was surprised at how quickly it needed to be replaced (8 weeks of minimal/moderate use), however it worked find after the replacement.  Today I am getting the same error message with yesterday's  brand new cartridge. I am unable to print and being told the same cartridge must be replaced.  I have tried to take it out and put in back in several times and I have tried to restart the printer.  The only way I can get it to work is without the new cartridge and using a single color cartridge. 

[sandytechy20]

@mlang

Welcome to HP support community.

Clean the electrical contacts

1. Turn the printer on.

2. Open the door to access the ink cartridges.

3. Wait until the carriage stops moving before you continue.

4. Remove the ink cartridge indicated in the error message from its slot, holding it by its side.

      CAUTION: 

   Do not touch the copper-colored contacts or the ink nozzles. Touching these parts can result in clogs, ink failure, and bad electrical connections.

5. Remove any protective tape that still might be on the contacts.

      CAUTION: 

   Do not touch or try to remove the copper electrical strip.

   

6. Lightly dampen a lint-free cloth with distilled water, and then clean only the copper-colored contacts on the ink cartridge.

   

7. Lightly dampen a lint-free cloth with distilled water, and then clean the electrical contacts in the carriage, located inside the printer.

   

8. Wait 10 minutes for the contacts to dry.

9. Reinsert the ink cartridge.

   • Insert the black ink cartridge into the right slot.

   • Insert the tri-color ink cartridge into the left slot.

10. Repeat these steps for the other ink cartridge, if necessary.

11. Close the ink cartridge access door.

12. If the error persists, repeat the previous steps to clean the ink cartridge and carriage contacts a second time.

13. Check for the error message.

You can refer this HP document for more assistance:- Click here

I hope that helps.

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

Cheers.