Officejet 4652 connected but keep getting "error" when trying to print

[Bayviewfour]

Officejet 4652 all in one printer - keep getting "Error" message when trying to print even though it shows as connected to my network

[Jay_G24]

 Hi @Bayviewfour

I'd like to help!

Try the below suggestions -

Reset the product

With the printer turned on, disconnect the power cord from the rear of the printer.

Unplug the power cord from the wall outlet.

Wait at least 60 seconds.

Plug the power cord back into the wall outlet.

Reconnect the power cord to the printer.

Turn the printer on. HP recommends plugging the printer directly into a wall outlet.

 Also, try updating the printer's firmware -HP Printers - Updating or Upgrading Printer Firmware  

 Use HP Print and Scan Doctor to check connectivity

Download a special version of HP Print and Scan Doctor specifically created to help with printer offline conditions.

1. Download HP Print and Scan Doctor.
2. Run HPPSdr.exe from the download location on your computer.
3. Once HP Print and Scan Doctor opens, click Start, and then select your printer.
   • If your printer in not in the list, turn it off and on, and then click Retry.
   • If there is a connection problem, follow the instructions in HP Print and Scan Doctor.
4. If a screen prompts you to turn on printer updates, click Yes.
5. If a screen prompts you to make your printer the default printer, click Yes.

Set a manual IP-

To set a manual IP and try the steps below -

--->Touch on the wifi icon ((i)) on the printer, and take down the IP address 

--->Open a web browser (ex Chrome or Mozilla) and type in the printer's IP

--->then go to network ---> general ---> network protocols ---> select IPV4 only-->apply 

--->go to wireless ---> wireless 802.11---> select manual ip ---> apply

--->Enter 8.8.8.8 for the first DNS and 8.8.4.4 for the second DNS.  

--->then go to settings on the main ews page --> power management ---> select sleep mode to max 15min

 Connect the printer to TCP/IP port

 --->Touch on the wifi icon ((i)) on the printer, and take down the IP address 

a. Click Start/Devices and Printers.  Right-click on your HP Printer.  Select Printer Properties.  Select the Ports tab at the top.

b.    Select Add Port.  Select Standard TCP/IP Port.  Select New Port.

c.    Follow the Add Port Wizard.  Under Printer Name or IP Address, .  Example:  192.168.1.15.  The IP address will be copied under Port Name.  

d.    Select Next and Finish the Wizard.

Hope this helps! Keep me posted. 

And, Welcome to the HP Support Community. 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping