Officejet Pro 7720 Offline

[Mac06107]

I have an (HP OfficeJet Pro 7720 series PCL-3) that will not come off Offline status.

HP Smart will not run, I have installed appropriate drivers, but no luck.

I am trying to reset to manufacturer standards, this is a used printer, and at this point, I have spend way to long getting this to work.

I understand the printer needs a unique code to do this, but I don't know where to get this?

Any help would be appreciated.

[Irfan_06]

Hi @Mac06107,

Welcome to the HP Support Community.

Thank you for posting your query, I will be glad to assist you.

I see that you are facing an issue with your Printer showing offline.

A) Please follow the steps below to perform a power drain.

1) Take out the cartridges

2) Unplug the power cord from the printer & wall.

3) Press and hold the power button down for 15 seconds and release the power button, wait for about 30 seconds.

4) Plug the power cord back into the printer and wall, ensure the printer is plugged into the wall & not into a surge protector.

5) Insert the cartridges back into the printer.

Remove the cartridges > Unplug the power cord > Wait for 30 seconds > Plug the power cord back in > Insert the cartridges

B) Kindly refer to the steps on this link to update the printer firmware and let me know if that resolves the issue.

C) If the issue still persists, please follow the steps below to connect your printer to the network again.

1) Uninstall the HP smart app by click on this link, Restart the computer or mobile device to clear possible error conditions.

2) Enable Wi-Fi setup mode: When you turn on your printer for the first time, it is temporarily placed in Wi-Fi setup mode so that it can be discovered during setup. Use the printer control panel to restore Wi-Fi setup mode, and then set up the printer again. Go to Restore Wi-Fi setup mode on your HP printer for more information.

3) Refer to this link to use the HP smart app on your phone/tablet/PC to add a printer.

Note: Enable Bluetooth for an HP Smart app setup: Enable Bluetooth on your computer or mobile device so that HP Smart can detect the printer during the setup.

Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!

I hope this helps.

Take care and have a great day ahead!

Irwin6

HP Support