Officejet Pro 8035 Error 71.02.4A

[HamPrint8035]

I have an Officejet Pro All in one 8035 printer with an error of 71.02.4A message.   I tried to use virtual assistant to resolve to no avail.  The closest I could find to the error was the cartridges are stuck to the right side.  I can't remove the cartridges since the tray is stuck to the right.    I've done all the normal stuff like turning off and on the printer, including unplugging it and restarting, , checking for paper jams, product updates, rebooting the wireless part.  Any other ideas?  Thanks.

[Nal_NR]

Hi @HamPrint8035t,

Welcome to the HP support communtiy.

I understand that you are getting a carriage jam issue on the printer and it shows Event code: 71.02.4A, I am glad to assist you to fix this issue.

Check for obstructions in the carriage path to make sure the carriage path is not blocked.

With the printer on, disconnect the power cord from the rear of the printer.

If your printer has a battery, remove the battery.

Open the door to access the carriage inside of the printer.

Examples of carriage access doors

Look in the carriage path for debris such as crumpled paper or dislodged labels, and then remove any that you find.

Example of a printer with debris in the carriage path

If the carriage on your printer has a latch, make sure it is closed.

Use your hand to move the carriage to each side, making sure it moves freely. If the carriage is stalled or docked to one side of the printer and you cannot move it, continue with these steps.

Close the carriage access door.

Reconnect the power cord to the rear of the printer, and then turn the printer on.

Reset the printer

An error might continue to display after the jam is cleared. To clear the error state, reset the printer, connecting the power cord directly to a wall outlet to make sure the power source is stable and prevent more carriage jams.

With the printer turned on, disconnect the power cord from the printer.

Unplug the power cord from the power source.

Wait 60 seconds.

Reconnect the power cord to a wall outlet and to the printer.

Update the printer firmware to install the latest updates

Click here for the steps.

Hope this helps! Keep me posted for further assistance.
Please click “Accepted Solution” if you feel my post solved your issue, it will help others find the solution. Click the “Kudos/Thumbs Up" on the bottom right to say “Thanks” for helping!

[Nal_NR]

Hi @HamPrint8035,

Hope I was able to fix the issue. If you need further assistance, feel free to reach out to us. 

Give us some reinforcement by clicking the Accepted Solution button, that'll help us and others see that we've got the answers and did reply to you!