Printhead: Missing, Failed or Incompatible and Printer Failure 0xc19a0003 errors

[OVICTOR1970]

Printhead: Missing, Failed or Incompatible and Printer Failure 0xc19a0003 errors

[Mans]

@OVICTOR1970 

Hello,

In some cases, remove the ink cartridges and reset the printer can solve the error.

1. Turn on the printer.
2. Before continuing, wait until the printer is idle and silent.
3. Disconnect the USB cable from the back of the printer. If your printer has a network or wireless connection, leave it connected.
4. Remove the ink cartridges of the printer.
5. With the printer turned on, unplug the power cord from the back of the printer and from the wall outlet.
6. Wait at least 60 seconds.
7. Plug the power cord into the outlet.

   NOTE:  HP then recommends reconnecting the printer's power cord directly into a wall outlet.

8. Reconnect the power cord to the back of the printer.
9. Turn on the printer, if it does not automatically make it.
   It is possible that the printer goes through a warm-up cycle. It is also possible that the printer lights blink and the carriage moves.
10. Wait until the preheat cycle and until the printer is idle and silent before continuing.
11. Reinsert the ink cartridge, and then close the access door to the cartridges.
12. Print a calibration page, if prompted.
13. If you disconnected the USB cable, reconnect it to the back of the product.
14. Try to print.

If the issue continues, you can perform manual cleaning of the printer's printhead as shown in the HP video below.

After manually cleaning the printheads, the automated tooling must be carried out.

To clean the printhead from the control panel

1. Load Letter, A4, or Legal unused plain white paper into the main input tray.
   
2. Touch Right arrow (), and then touch Setup ().
3. Touch Tools, and then touch Clean Printhead.
   

Don't hesitate to contact us in case of need.

Best regards,