printer error state

[jmk82633]

My printer paper jammed, once cleaned out, the printer is in error state...How do I fix this problem??????

There is no jam, it has new ink, downloaded updates, all seems correct but goes into error state

[KrazyToad]

@jmk82633

Welcome to HP Support Forums. A really great platform for posting all your questions and finding solutions.

I have gone through your Post  and I would like to help

Let's start with a printer reset

(1) Turn the printer on, if it is not already on.
(2) Wait until the printer is idle and silent before you continue.
(3) With the printer turned on, disconnect the power cord from the rear of the printer.
(4) Unplug the power cord from the wall outlet.
(5) Wait at least 60 seconds.
(6) Plug the power cord back into the wall outlet.
 NOTE: HP recommends connecting the printer power cord directly to the wall outlet.
(7) Reconnect the power cord to the rear of the printer.
(8) Turn on the printer, if it does not automatically turn on.

The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.
Wait until the warm-up period finishes and your printer is idle and silent before you proceed

Also update the Printer Firmware from this Link: https://support.hp.com/us-en/drivers

I suggest you download and run the HP Print And Scan Doctor from this Link: ftp://ftp.hp.com/pub/printers/hppsdr/patches/HPPSdr.exe

Run PSDR v5.0.2 

Once the PSDR detects the Printer, it will show up the IP address and Software Status. 

Select the correct Printer and click on Next. 

PSDR will check if the Printer is on the Network and communication between the PC and the Printer. Once the connection check is done, click on Fix Printing 

Once PSDR goes through all checks and automatic fixes, click on Print a test page. 

Regardless if PSDR printed the test page or not, click on “NO PRINT” 

PSDR will then notify you that there is an update available, click on continue, and PSDR will apply the patch and ask for a reboot. 

Post restart the PSDR will run automatically to check for more issue.  If no issue found close PSDR.

Try printing and let me know how it goes

Thank you and have a great day 😊

If the information I've provided was helpful, give us some reinforcement by clicking the "Solution Accepted" on this Post and it will also help other community members with similar issue.