HP Photosmart 3210 All-in-One Inktsysteem werkt niet. Kan niet kopiëren, faxen ontvangen of afdruk

[cleut0051]

HP Photosmart  3210 All-in-One

Inktsysteem werkt niet.

Kan niet kopiëren, faxen ontvangen of afdrukken.

Raadpleeg de printerdoc.

Fout 0xc18a0206

[danny-r · Accepted solution]

@cleut0051

Thank you for visiting our English HP Support Community. We are only able to reply to posts written in English. To ensure a quick response it would be advisable to post your question in English. The following links are here to assist you if you prefer to post in the following Language Community.
 

German: HP Kundenforum
Spanish: Foro de usuarios de HP
French: Forum des utilisateurs
Portuguese: Fórum dos usuários HP
Chinese: 惠普个人客户支持论坛
Korean: HP 지식커뮤니티

Thank you for your understanding.
 

[cleut0051]

HP Photosmart  3210 All-in-One

Inksystem is not working.

Cannot copy, receive faxes or print.

See printerdoc.

Error 0xc18a0206

[sandytechy20]

@cleut0051

Welcome to HP forums.

Reset the printer.

1. Turn on the printer.

2. Wait until the printer is idle and silent before you continue.

3. Disconnect the USB cable from the rear of the printer. If your printer has a network or wireless connection, leave your printer connected to the network.

4. Remove the ink cartridges from the printer.

5. With the printer turned on, disconnect the power cord from the rear of the printer and from the wall outlet or power strip.

6. Wait at least 60 seconds.

7. Plug the power cord back into the wall outlet.

   NOTE: 

   HP recommends connecting the printer power cord directly to a wall outlet.

8. Reconnect the power cord to the rear of the printer.

9. Turn on the printer, if it does not automatically turn on.

   The printer might go through a warm-up period. The printer lights might flash, and the carriage might move.

10. Wait until the warm-up period finishes and your printer is idle and silent before you proceed.

11. Reinsert the ink cartridges, and then close the ink cartridge access door.

12. If you receive a prompt to print a calibration page, do so.

13. If you disconnected the USB cable, reconnect it to the rear of the printer.

14. Try to print.

Let me know how it goes.

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

Cheers.

[cleut0051]

Hello Sandytechy20,

I tried several times to get my printer to work again following up your instructions, but without luck! The printer does still not work and the same message keeps turning up! What else can I try to do?

[sandytechy20]

@cleut0051

Update the printer firmware

Refer this HP document for the steps to update:- Click here

I hope that helps.

To thank me for my efforts to help you, please mark my post as an accepted solution so that it benefits several others.

Cheers.