cancel
Showing results for 
Search instead for 
Did you mean: 
Common problems for INSTANT INK, HP+ PLANS: INK AND TONER
We would like to share some of the most frequently asked questions about Instant Ink. Check out this link: HP INSTANT INK, HP+ PLANS: INK AND TONER. .
jsesi229
New member
1 0 0 0
Message 1 of 2
73
Flag Post

Error message of "Manual Feed. Plain, Letter Press OK to Continue" whenever printing

HP Recommended
Color LaserJet Pro MFP M277c6
Microsoft Windows 10 (64-bit)

Hello,

As of about 2 weeks ago, I am receiving the error message "Manual Feed. Plain, Letter Press OK to Continue" whenever sending a job. If I restart my printer, I can print one or two jobs fine. After a couple of jobs, the error message continues to show. Thanks in advance for any and all help. 

1 REPLY 1
Jay_G24
HP Support Agent
HP Support Agent
10,176 10,149 712 808
Message 2 of 2
Flag Post
HP Recommended

Hi @jsesi229,

 

I'd like to help!

 

Try the below suggestions -

 

Check the paper, and then reload it

Check the paper stack for defects such as wrinkled, torn, or bent pieces that might cause a pick-up issue.

  1. Remove any paper from the paper tray.

  2. Remove any severely bent, wrinkled, or torn paper found in the stack.

  3. Check for obstructions inside the paper tray. Make sure nothing blocks the paper from engaging with the rollers.

  4. Make sure the paper stack is even on all sides.

  5. Load the stack of paper into the paper tray.

    Examples of loading paper
  6. Close or push in the paper tray.

  7. Select the correct paper size on the printer control panel or in the printer software.

Clean the paper pick rollers

 

Clean dirt or debris from the paper pick rollers to resolve paper feed issues.

Clean the paper pick rollers (top paper tray)

Clean the paper pick rollers (under printer)

Clean the paper pick rollers (inside printer)

 

For instructions refer to - An 'Out of Paper' error displays, printer does not pick paper

 

Reset the printer

Reset the printer to recover from printer errors or failures.

  1. With the printer turned on, disconnect the power cord from the printer.

  2. Unplug the power cord from the power source.

  3. Wait 60 seconds.

  4. Reconnect the power cord to a wall outlet and to the printer.

    NOTE: 

    HP recommends plugging the printer directly into a wall outlet.

  5. Turn on the printer to complete the reset.

Also, try updating the printer's firmware - HP Printers - Updating or Upgrading Printer Firmware 

 

Hope this helps! Keep me posted. 

 

And, Welcome to the HP Support Community. 

 

Please click “Accept as Solution” if you feel my post solved your issue, it will help others find the solution.

Click the “Kudos, Thumbs Up" on the bottom right to say “Thanks” for helping

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation