-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
-
×InformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center. -
- HP Community
- Printers
- Printing Errors or Lights & Stuck Print Jobs
- HP LaserJet M608 Stuck at Initializing

Create an account on the HP Community to personalize your profile and ask a question
04-06-2021 11:00 AM
HP LaserJet M608, Model: K0Q17A
Initializing up to 35,000 overnight, won't fully boot.
I went into the pre-boot menu to attempt a partial clean and cold reset and neither resulted in success.
I ran diagnostics and the only error was on the Hard Disk, the error is 90.0A.65: There is no disk installed.
I attempted to apply a firmware update from the pre-boot menu but it wouldn't detect the flash drive so I will try a different flash drive later today. Any other suggestions? Thank you!
Solved! Go to Solution.
Accepted Solutions
04-07-2021 07:34 AM
I was able to resolve this. I downloaded the latest firmware and copied it to a flash drive and applied the firmware update from the Pre-boot menu. I had to use the USB port that's found on the back of the printer, not the front USB port.
04-07-2021 07:34 AM
I was able to resolve this. I downloaded the latest firmware and copied it to a flash drive and applied the firmware update from the Pre-boot menu. I had to use the USB port that's found on the back of the printer, not the front USB port.